A dash cam sits behind your windshield all year. During summer the cabin can pass 40°C degrees. In winter it can sit below -20°C for a full night. The part inside that takes the beating is the one that keeps the camera alive when power drops: either a small lithium battery or a supercapacitor. The choice matters more in Canada than you'd think.
This post explains how each type behaves, what changes in parking mode, and what to look for on the spec sheet. Runtime and cold tolerance depend on the exact camera, its capacity, the temperature and how it is wired, so treat what follows as general guidance and check your model's documentation.
The role of the internal power supply
When the car is turned off, the camera loses power from the vehicle. The internal battery or capacitor gives it a short window to finish writing the current video file and shut down cleanly. Without that, the last clip can be corrupted, and that is often the clip you needed.
That is the main job in both designs. Some battery-based cameras can also record for a short time on their own. Capacitor cameras generally cannot, because a capacitor stores far less energy.
How a battery dash cam handles cold
Lithium-ion batteries are sensitive to temperature in both directions.
In the cold, capacity drops and the camera may shut down or fail to start. Many lithium cells also should not be charged below freezing, so a camera that powers up in a frozen car may be charging a battery it should not charge yet.
In the heat, the battery ages faster and can swell over time. A windshield in summer sun is a hard environment.
Over time, capacity fades, so a camera that held a charge for a minute in year one may hold far less by year three. If you're finding that your dashcam isn't holding charge like it used to, it might be time to upgrade. Contact our team at Car Systems Installation, we'll be able to help you decide and install a new dashcam for your car.
Manufacturers publish an operating temperature range for each camera. For battery models, that range is often narrower than for capacitor models. If your car sleeps outside through an Ontario winter, check the lower limit on the spec sheet before you buy.
How a capacitor dash cam handles cold
Supercapacitors store charge physically instead of through a chemical reaction. That is why they generally tolerate a wider temperature range and a longer lifespan. They do not swell the way a lithium cell can, and they do not share the same cold-charging concern.
The trade-off is energy. A capacitor holds enough power to save the file and shut down, but not much more. That is fine for most drivers, because the clip is saved safely and the camera restarts cleanly the next time the car starts.
What changes with parking mode
Parking mode records while the car is off, so it needs a steady power source. Neither a small battery nor a capacitor can run it for long. Parking mode usually relies on a hardwire kit connected to the vehicle's fuse box, and some people add a separate dash cam battery pack.
This is where cold weather matters most for the car, not only the camera. Your car battery already has less capacity in the cold. A good hardwire kit includes a low-voltage cut-off, which turns the camera off before the car battery drops too low to start the engine. In winter, many owners choose a more conservative cut-off setting. How long parking mode runs depends on the camera's power draw, your car battery's health and capacity, the temperature, and the cut-off you set. There is no single number that fits every car.
Which should you choose?
Car parked outside all winter, or a long commute in extreme cold: a capacitor camera is usually the safer pick on temperature tolerance.
Parked in a heated garage, mostly short drives: either type can work well, and video quality may matter more.
Parking mode matters to you: plan for a proper hardwire install with low-voltage protection, whichever type you choose.
Hot summer cabins: capacitors tend to hold up better over time than lithium cells.
Three things to check on any spec sheet
1. The stated operating temperature range, both low and high.
2. Whether parking mode is supported and what power setup it needs.
3. Whether the camera has a built-in voltage cut-off or relies on the hardwire kit.
Installation matters as much as the camera
For more on picking a camera, read our guide to the benefits of dash camera installation.
